1 - 2 minutes readComplete Steps for Using RMAN Catalog

Recovery manager is a platform independent utility for coordinating your backup and restoration procedures across multiple servers.

Create Recovery Catalog

• First create a user to hold the recovery catalog:

CONNECT sys/password@wk1 AS SYSDBA

• Create tablepsace to hold repository

CREATE TABLESPACE “RMAN”
DATAFILE ‘C:ORACLEORADATAW2K1RMAN01.DBF’ SIZE 6208K REUSE
AUTOEXTEND ON NEXT 64K MAXSIZE 32767M
EXTENT MANAGEMENT LOCAL
SEGMENT SPACE MANAGEMENT AUTO;

• Create rman schema owner

CREATE USER rman IDENTIFIED BY rman
TEMPORARY TABLESPACE temp
DEFAULT TABLESPACE rman
QUOTA UNLIMITED ON rman;
GRANT connect, resource, recovery_catalog_owner TO rman;

• Then create the recovery catalog:

C:>rman catalog=rman/rman@w2k1
Recovery Manager: Release 9.2.0.1.0 – Production
Copyright (c) 1995, 2002, Oracle Corporation. All rights reserved.
Connected to recovery catalog database
Recovery catalog is not installed

RMAN> create catalog tablespace “RMAN”;
Recovery catalog created

RMAN> exit
Recovery Manager complete.

C:>Register Database

• Each database to be backed up by RMAN must be registered:

C:>rman catalog=rman/rman@w2k1 target=sys/password@w2k2

Recovery Manager: Release 9.2.0.1.0 – Production
Copyright (c) 1995, 2002, Oracle Corporation. All rights reserved.
connected to target database: W2K2 (DBID=1371963417)
connected to recovery catalog database

RMAN> register database;
database registered in recovery catalog
starting full resync of recovery catalog
full resync complete

• The recovery catalog should be resyncronized on a regular basis so that changes to the database structure and presence of new archive logs is recorded. Some commands perform partial and full resyncs implicitly, but if you are in doubt you can perform a full resync using the follwoing command:

RMAN> resync catalog;